Project 93' Mazda RX7 Street Car

We are currently building a project 1993 Mazda RX7 street car. It is our shop car and will be the test mule for many upcoming projects.
We have designed and built a new SR high flow intercooler kit that is used in our 1993 Mazda RX7 . It allows the stock battery to be left in its original location . Our fuel system has been upgraded with our SR high flow fuel pump to make sure that our1993 Mazda RX7 survives all of the abuse we will give it on the street and at the track. Our Ultimate SR aluminum radiator will be in and will be put to the test to make sure that our motor will always run cool. We used our SR fresh air intake system that pulls in air from the very front of the car where it is supposed to.
The SR stainless steel full 3 inch exhaust system is now installed in our 1993 Mazda RX7 . We have been tuning it with the new A'PEXi Power FC and putting it to the Dynojet, to test it with very good results so far.

 

Our dynojet sheet from our project 1993 Mazda RX-7 with our following modifications:

Our twin-turbo Project 1993 Mazda RX-7 was put on the dynojet. Our Project twin-turbo 1993 Mazda RX-7 is a bone stock 50,000 mile 13B REW engine with all factory
emissions including a catalytic converter and even a smog pump. It has our Level III system installed on it.

This includes: our SR horizontal intercooler, SR air box, SR downpipe , SR catback system, and our SR Tuned A'PEXi Power FC.

At only 12 PSI boost, it produced 323 (**corrected ) Horsepower with 284 ft. pounds of torque.
( **336 uncorrected Horsepower, 295 Ft. pounds of torque)

Project Twin-Turbo 1993 Mazda RX-7

 



Click to enlarge

 

 


Site Map
Contact Us

Website designed by Brodie Peterson and SRM
Website maintained by SRM.

Copyright 2002 SRMotorsports.com. All rights reserved.